Hot Cocoa Bunny Bombs

Hot Cocoa Bunny Bombs 

Chocolate of your choice;

Our Bunny silicone chocolate mold;

Hot cocoa powder and mini marshmallows;

Piping hot milk.

Start your bombs off by melting chocolate either on the stove or the microwave, then coat the inside of your mold with a healthy layer.

Next, put the mold in the fridge for 10 minutes, and make sure your chocolate shell does not need any reinforcing before you try to pop it out.  (If it does, just load up your mold with another layer of chocolate, dump out excess chocolate.)

Very carefully remove your cooled chocolate from the mold, and fill Bunny with your hot cocoa (about 1 Tbsp) & mini marshmallows.  To seal your Bunny follow “Flat Back Method “below :

Flat Back Method (Sealing Bunny)

-Spread some chocolate on a 5x5 inch square of parchment paper. Place square on top of Chocolate bunny’s open bottom. Flip Bunny over (so it is upright and parchment paper is underneath). Pop in Fridge for 5 minutes. Then cut excess chocolate on edges off with a knife or razor. Lift bunny from Paper & Fill in any gaps with melted chocolate.

Pop Bunny in a mug and pour piping hot milk on top and watch the magic happen!

Another great option is to fill your hollow bunny shell with a peanut butter filling or M&Ms (Kids love breaking the chocolate shell and finding candies inside!

Peanut Butter Filling:

• 1 1/2 tablespoons butter
• 1/2 cup chunky style peanut butter
• 3/4 cup confectioners' sugar

Cut butter in small pieces & put in small saucepan over low heat. Add peanut butter & stir until melted. Remove from heat. Stir in confectioner’s sugar & blend well. Add more sugar, as necessary to make a pliable mass. Wrap in plastic & refrigerate for about an hour. Use filling inside hollow bunny shells, Use flat back method above to seal closed.

ATEASE is a military-owned family business based in Bath, Maine.  We strive to distribute long lasting, high quality, feel good home products.  If you have any questions, please reach out atAteaseaccents@yahoo.com.

Additional tips: For removing Bunny from mold: Apply a second layer of chocolate. Make sure Chocolate is not too cold cause then it breaks right away! Turn the bunny opening down when it is hardening so the sides get thicker

Take butt out first and then straight up by the ears!